Whole-home repiping
Galvanised or failing copper replaced throughout, planned to keep your water on as much as possible.
Repiping & pipe replacement in Etobicoke & the GTA
The work nobody sees and everybody depends on. Ageing pipe replaced properly, with the rest left alone.
New water lines
Supply lines run to additions, basements, garages and outbuildings, sized correctly for the demand.
Drain & vent piping
The half of plumbing nobody thinks about. Get the venting wrong and nothing drains right.
Leak detection
Finding the leak before opening the wall. We narrow it down first, then open the smallest hole that works.
Pipe repair
A single failed section replaced where the rest of the run is sound. Not every problem is a repipe.
Pressure & flow diagnosis
Chronically poor pressure often traces back to pipe material or sizing. We find out which.
Why Old Pipes Should Not Wait
Housing stock across Etobicoke, older Mississauga and parts of Oakville and Burlington still runs galvanised steel or early copper. Galvanised corrodes from the inside — the pipe narrows year after year until pressure drops and rusty water shows up first thing in the morning. By the time you notice, the pipe has been closing for a decade.
Common Repiping Myths
“If the water still runs, the pipes are fine.”
Galvanised pipe closes gradually from the inside. Water still runs right up until it barely does. Falling pressure and discoloured water in the morning are the pipe telling you where it is in that process.
“Repiping means tearing the whole house apart.”
It means opening access points, not gutting rooms. A planned repipe is far less invasive than people expect — and considerably less invasive than the emergency repair after a line fails inside a finished wall.
“Any leak means the whole system needs replacing.”
No. Plenty of leaks are a single failed section on an otherwise sound run, and that is what we will quote. We recommend a repipe when the evidence supports it, not by default.
“Rusty water is just the city’s problem.”
Sometimes it is, briefly, after mains work. If it is yours alone, worst first thing in the morning, and clears after running the tap, that is corrosion inside your own pipe.
Our Process
Step 1
Assess what you actually have
We check pipe material, condition, pressure and where the problems concentrate. Sometimes the answer is a section, not a system.
Step 2
Plan the route and the access
We map the runs to minimise opening walls and to keep your water on for as much of the job as possible. You know the plan and the price before we start.
Step 3
Replace and pressure test
New line run to code, pressure tested, and left with the access work clean. What we did not need to touch, we did not touch.
Repiping or Pipe Repair?
Whether it is a single line or a whole-home repipe, we deliver dependable solutions built to last.
Areas We Serve
Milton • Oakville • Burlington • Mississauga • Hamilton • Toronto • Etobicoke • Halton Hills • Georgetown • Waterdown
Frequently Asked Questions
How do I know if my house needs repiping?
The usual signs are falling water pressure, discoloured or rusty water first thing in the morning, repeated pinhole leaks, or knowing the home still has galvanised pipe. Any one of those is worth an assessment. Not all of them mean a repipe.
How long does a whole-home repipe take?
It depends on the size of the home and the access. We give you a schedule and a firm price up front, and we plan the work to keep your water on for as much of it as possible.
Can you find a leak without opening the wall?
We narrow it down first using pressure, access points and the evidence at hand, then open the smallest area that gets us to it. The goal is always the smallest hole that solves the problem.
Is a pinhole leak in copper a warning sign?
Often, yes. A single pinhole can be bad luck. Repeated pinholes on the same run usually mean the pipe is at the end of its life and will keep failing.